A Compact Create Mod Tree Farm Guide

Materials required: (* you can use Linear Chassis for the body and make them sticky with slime instead of supergluing the whole thing if preferred)


Dig a 7x7 hole, but leave 1 block in each corner:



In the center, dig a 3x3 hole 2 blocks deep, leaving one bottom corner intact:



Place a waterweel in the center of the bottom of the hole, and place the water next to the intact corner. The wheel should start spinning:



Cover up the hole leaving only the center, and place a shaft in the remaining hole (this shaft should also be spinning):



Place the Mechanical Bearing on top of this shaft:



Place your body material in a long C-shape 3 blocks high and 4 blocks wide. Put 3 Mechanical Saws on this side like so:



Place 3 deployers on the back. If they're facing the wrong way, you can rotate them with a wrench:



Place a Chest and Portable Storage Interface in the center of the body. Set up another Interface 1 block away facing inward, attached to an extraction method of your choice:



Place a temporary block next to the deployers and right-click it with superglue:



Right-click the opposite corner block (the rightmost Saw) with superglue to glue the whole thing together:



Set the deployers to use saplings by right-clicking the filter with a sapling:



Right-click the top of the Bearing with an empty hand to turn on the machine:



Being careful not to get hit by the saws, replace the dirt and plant as many saplings as are available:



After a short while, trees will begin growing and immediately get chopped down by the saws. If lined up correctly, the two interfaces will extend and connect on each rotation.
Farm complete!